Starting engine
WARNING
● There are some general precautions when starting the engine.
Carefully read the precautions described in “General precautions when starting engine” F7- 9.
● If the indicator on the pushbutton ignition switch flashes in green after the engine has started, never drive the vehicle.
The steering is still locked, and it may result in an accident.
CAUTION
● When the operation indicator on the push-button ignition switch is flashing in orange, there may be a malfunction with the vehicle.
Contact a SUBARU dealer immediately.
● If the indicator on the pushbutton
ignition switch is flashing
in green after the engine has
started, it means that the steering
is still locked. Depress the brake
pedal while moving the steering
wheel to the right and left, and
press the push-button ignition
switch
● Do not continue pushing the
push-button ignition switch for
more than 10 seconds. Doing so
could cause a malfunction. If the
engine does not start, stop pushing
the push-button ignition
switch and turn off the engine.
Wait 10 seconds, and then push the push-button ignition switch to start the engine.
NOTE
● When the push-button ignition switch is pressed while depressing the brake pedal, the engine starter operates for a maximum of 10 seconds and after starting the engine, the starter stops automatically.
● When the push-button ignition switch is pressed while depressing the brake pedal, the engine can be started regardless of the status of the push-button ignition switch.
● If the security indicator light illuminates when you attempt to start the engine but the engine does not start, press the push-button ignition switch to switch the power to “OFF” and then try to start the engine again.
● If the engine does not start, press the push-button ignition switch without depressing the brake pedal to switch the power to “OFF”. Then, while depressing the brake pedal more forcefully, press the push-button ignition switch.
● The engine start procedures may not function depending on the radio wave conditions around the vehicle. In such a case, refer to “Starting engine” .
● If the vehicle battery is discharged, the steering cannot be unlocked.
Charge the battery.
When the push-button ignition switch is pressed while depressing the brake pedal, the engine will start. The starting procedure for the engine is as follows.
1. Carry the access key, and sit in the driver’s seat.
2. Apply the parking brake.
3. Shift the select lever into the “P” position. The engine can also start when the select lever is in the “N” position, however, for safety reasons, start in the “P” position.
4. Depress the brake pedal until the operation indicator on the push-button ignition switch turns green. When starting with the select lever in the “N” position, the indicator does not turn green.
5. While depressing the brake pedal, press the push-button ignition switch.
NOTE
● While pressing the select lever button in, the indicator on the push-button ignition switch will not turn green even when the select lever is in the “P” position.
● In case the engine does not start by the normal engine start procedure, move the select lever to the “P” position, and switch the power to “ACC”.
Depress the brake pedal, and press the push-button ignition switch for at least 15 seconds. The engine may start. Only use this engine start procedure in case of emergency.
● When the engine is not started, the brake pedal may feel stiff. In such a case, depress the brake pedal more forcefully than usual. Check that the operation indicator on the push-button ignition switch turns green, and press the push-button ignition switch to start the engine.