1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly.

2. Slide the rear combination light assembly rearward and remove it from the vehicle.

1) Stop/tail light (This light is also used as the rear side marker light.) 2) Backup light
3) Rear turn

3. Remove the bulb socket from the rear combination light assembly by turning it counterclockwise.

4. Pull the bulb out of the bulb socket and replace it with a new one.

5. Set the bulb socket into the rear combination light assembly and turn it clockwise until it locks.

6. Put the rear combination light assembly into place while aligning the 2 guide pins and a catch with the guide holes and a clip on the vehicle.

7. Tighten the upper and lower screws.