Remote keyless entry system

CAUTION

● Do not expose the remote transmitter to severe shocks, such as those experienced as a result of dropping or throwing.

● Do not take the remote transmitter apart except when replacing the battery.

● Do not get the remote transmitter wet. If it gets wet, wipe it dry with a cloth immediately.

● When you carry the remote transmitter on an airplane, do not press the button of the remote transmitter while in the airplane.

When any button of the remote transmitter is pressed, radio waves are sent and may affect the operation of the airplane.

When you carry the remote transmitter in a bag on an airplane, take measures to prevent the buttons of the remote transmitter from being pressed.

● FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC ID: CWTWB1U811
FCC ID: CWTWBU766
FCC ID: HYQ14ACX

This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

NOTE

L’utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes: (1) il ne doit pas produire de brouillage, et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.

For models with “keyless access with push-button start system”, the access key is used as the transmitter for the remote keyless entry system. For models without “keyless access with push-button start system”, the transmitter for the remote keyless entry system is located inside the key head.

The remote keyless entry system has the following functions.

● Locking and unlocking the doors (and rear gate) without a key ● Unlocking the rear gate without a key ● Sounding a panic alarm ● Arming and disarming the alarm system.

For detailed information, refer to “Alarm system” .

The operable distance of the remote keyless entry system is approximately 30 feet (10 meters). However, this distance will vary depending on environmental conditions. The system’s operable distance will be shorter in areas near a facility or electronic equipment emitting strong radio waves such as a power plant, broadcast station, TV tower, or remote controller of home electronic appliances.

NOTE

● For models with “keyless access with push-button start system”, the remote keyless entry system will not be activated when the push-button ignition switch is in any position other than the “OFF” position.

● For models without “keyless access with push-button start system”, the remote keyless entry system will not be activated when the key is inserted in the ignition switch.

Access key


Access key

1) Lock/arm button
2) Unlock/disarm button
3) Rear gate unlock button 4) PANIC button

Transmitter


Transmitter

1) Lock/arm button
2) Unlock/disarm button
3) Rear gate unlock button 4) PANIC button

NOTE

The hazard warning flashers will flash once or twice when the transmitter button is pressed in the following cases.

– When locking the doors – When unlocking the doors – When unlocking the rear gate

Operation of the hazard warning flashers in the above cases can be set to “On” or “Off” by a SUBARU dealer.

Consult your SUBARU dealer for details.

Also, for models with a multi function display, the setting can be changed using the display. For details, refer to “Hazard warning flasher setting” .